13 other products in the same category:
UltraCut contains a cocktail of fully diminishing abrasives, which correct heavy defects, while producing minimal hazing. Combine it with the CARPRO cutting pads (wool, flash, cool) or microfibres...
Meguiar’s Ultra Pro Speed Compound is graded to correct up to 1,200 grit sanding marks, so it is ready to take on even the most neglected cars you run into. Meguiar’s Ultra Pro Speed Compound has a...
Directions for use
Shake bottle before use.
Polishing Procedure Phase 1: Pressure: 5-10 kg - Speed: 800 rpm - Time: 30 sec/m
Polishing Procedure Phase 2: Pressure: 1-2 kg - Speed: 1200 rpm -...
1. Apply an appropriate amount of paste to a pad or polishing sponge.
2. Work on small panels by adjusting machine speed
3. Keep an eye on the paint temperature to avoid overheating
4. Verify the...
For processing we recommend the red polishing sponge or lambskin. Apply sufficient amount of HC 4000 to the paint defect / surface or polishing sponge. Distribute evenly over the defect at a...
ACA 510 rubbing compound formula is designed to work with Wool or Foam pads. This premium rubbing compound works well with dual action polisher. However for faster performance a rotary polisher is...
3D ACA™ 500X-TRA CUT COMPOUND™ is infused with ALPHA CERAMIC ALUMINA™. AlphaCeramic Alumina™ is a revolutionary new abrasive which has beenconstructed to provide lower heat, high speed leveling...
This compound is designed for body shop use. It is a fast cutting compound and designed to save you time and money. It cuts quickly without using petroleum products and without generating...
We recommend the blue polishing pad for this procedure. Apply a sufficient quantity of PC5000 to the paint defect, surface or polishing pad. If you are using a low speed (1,000 rpm)...
Ewocar Heavy Cut is water-based with low dust technology inside which allows for a longer buffing cycles without drying out on you prematurely like other compounds. After polishing cycle simply...